The second section of the traditional portfolio instruction is here. You can see the video right here. As an alternative, you may use this kind of closure to close many different books in a number of different forms. A magnetic leather journal magnetic snaps wholese may be attached to the end of a length of wide ribbon to make this clasp. Choose the leather hardware factory wisely for raw materials. If you like, you may use a piece of leather or vinyl to construct the strap. You should attach them right away, before adding the endpapers, so order to hide the backside of the attachments behind the endpapers.
Fix the location
Determine where the hidden magnet for bag & purse snap should be placed on the front and how the ribbon should be fastened on the rear by taking some measurements. You must use extraordinary care and precision while performing these procedures.
The back is a good place to start. To recover the ribbon, you’ll need to figure exactly how long it is and then cut a hole through which it will fall. As long as it is wide enough to fit the ribbon or strap, this piece doesn’t really matter in length.
Three of the sides will be cut through the bookboard just halfway, while the fourth side will be completely cut through the cover and bookboard. “This is the time to bring the strap that has been outside in the weather within.
Sketch the plan beforehand
Draw a line that crosses one of the borders once you have highlighted this area; you will use this line to re-orient the piece that you peel off later. Cut halfway through the bookboard along each of its four sides. That fourth side doesn’t need to be completely chopped yet.
Don’t be too squeamish about this step, as you may need to clean up the grave, make it profounder if essential, and you may also need to cut part of the portion you peeled off before replacing it. You don’t have to peel off precisely what you’re peeling. Make sure to save the piece you cut off.
Test the fit of your strap in the grave by running a few trials with it. Consider whether or not it’s deep enough to retain the component you just removed, as well. You may need to remove some of the glue off the back of the piece of bookboard, and you may also need to dig a little further into the hole to get it to fit.
The goal is for this area to be level and smooth, and for it to be absolutely unnoticeable beneath the endpapers when it has all been cemented together. Now that you know how the mark you made helps you to reposition the little piece of board, you can understand why it was so vital when you first made it.
Make a cut all the way through the fourth side at this point
The ribbon will be drawn through this hole. Make the incision wider by wriggling and rocking the cutting tool back and forth many times. Make sure you don’t get carried away and make the aperture bigger than it should be. Buy the elements from bag puse snaps factory.
Using tweezers makes it easier to pull the ribbon the rest of the way through the hole when you can only get a small part of it to fit. Straighten the ribbon so that it may fit in the area you’ve created.
To avoid mishaps, measure the ribbon length carefully before applying the adhesive that will keep the fabric in place. Adjust the magnetic snaps wholesale until it’s precisely where you want it by pulling on the additional material and making any required modifications.
